Fully automatic box molding machine recommended Machinery Co., Ltd. Shandong Linyi Zhuojie molding machine is a common casting machinery and equipment. When molding machine, pay attention to its operating points, to ensure the safe use of the work. Many people are not very understanding molding machine, as long as put into use, capable of functioning just fine. Proper and safe use of the molding machine, can extend the working life of the molding machine, and improve production quality. Important molding machine for safe operation as follows: 1, molding machine, the operator should be familiar with the molding machine mechanical parts, electrical components, operation program, lubrication system, etc., and other requirements specified in the device used. Compacted sand molding machine program four steps: tap, put into pressure head, compaction, put pressure head molding machine from the model program: table clamp, ejector pin rises, transported sand box, chassis department reset 2, molding machine, before starting the device, you should first check molding machine lubrication system is perfect, according to the provisions of fuel, check the tight parts are tightened, each operating handle is in the zero position (space), the valve action is flexible pipe without leakage, and then open the valve to let go of the total volume of gas in the pipeline and water. 3, non empty open, must be carried out under a load of test cases to check the working status is normal, for refueling places should be lubricated. After commissioning work can be carried out properly. 4, the molding machine must carefully observe the functioning of use, should be kept in operation with air blowing lubricating parts and operating parts of sand, non-sticky lubrication parts sand. 5, when the molding machine using the handle when opening and closing the valve action should be smooth. 6. To clean the table after each completed a modeling job, in order to carry out a second start modeling work. 7, after the molding machine after use, to handle back to zero (empty) position, close the valves, cleaning equipment, cleaning the site, to keep each sliding equipment (rotating) parts cleaning and lubrication, carefully close inspection tools, dies. Casting workhorse of choice for manufacturers of automatic level without box molding machine (latest) promotional video: http: //www.tudou.com/programs/view/e2LvCPbrHtw/